Maytag Washer F9 E1: Official Meaning and Checks

Does this guide apply?

Region

United States

Product family

Front Load Washers (URL category: Laundry/Washers/FrontLoadWashers/ErrorCodes/%22F%22ErrorCodes)

Exact models

Not listed in the cited source. Confirm the full model in the official manual.

Scope note

The cited source scope is Front Load Washers (URL category: Laundry/Washers/FrontLoadWashers/ErrorCodes/%22F%22ErrorCodes). Confirm the complete model number before applying the guidance; an empty model list does not imply all models.

Find the model label and official manual before ordering a part

Common paths to check

These are source-backed possibilities, not probability estimates for your specific unit.

• 01 Official source meaning: F9E1 Error Code - Long Drain Time This error code indicates the washer is unable to drain correctly.

Decision path

Safe checks, in order

1. 1

   Confirm code and model scope

   Compare the complete display and full model number with the cited manufacturer page or manual before applying any troubleshooting instruction.

   Expected: The official source explicitly covers the displayed code and product family.

   If not resolved: Contact manufacturer support with the full model and serial number.

2. 2

   Follow the official owner checks

   There are a few things you can check: Drain hose installation Drain pump filter clogged Door seal or bellow clogged Is the Drain hose extending more than 4.5" (113 mm) into the drainpipe? The drain hose may be too far inside the drainpipe (standpipe) or laundry tub. Drained water can siphon back into the washer if the drain hose extends too far. Ensure the drain hose does not extend more than 4.5" (113 mm) into the drainpipe or laundry tub. Using the U-shape drain hose form (as described in the Installation Instructions), will provide the correct drain hose length in the drainpipe or laundry tub. The maximum height for the drain hose is 96" from the bottom of the washer. Is the Drainpipe covered? Do not seal the drain hose into the drainpipe with tape. The drain hose should be loose yet secure. There must be a gap between the drain hose and the drain pipe to allow air to flow through. The air gap will break the suction. This will prevent water from continuously being sucked out of the machine (siphoning) as it fills. Have you Cleaned the Drain Pump Filter? (some models) The Drain Pump filter is located behind the bottom dispenser drawer (on some models). This filter should be cleaned occasionally. If it gets clogged, the washer will not drain well. CLICK HERE for more information about cleaning your Drain Pump Filter or see your Owner's Manual Models with a Storage Drawer Models without a Storage Drawer Have you Cleaned the Door Seal (bellow)? There are small drain holes…

   Expected: Only the user-accessible condition identified by the official source is corrected.

   If not resolved: Stop repeated resets and arrange qualified service if the code returns or the source directs service.

Reset and test

A user reset is not documented for this condition.

Important: A reset may clear the display but cannot repair the underlying condition; follow only the exact model-specific manufacturer procedure.

Related guides for this equipment

These links share the same brand and equipment family. A related guide does not prove that the codes have the same cause on your model.